Air Flow Products 730-1-000000-061007 90-degree Duct Boot

Product Description

The AIR FLOW PRODUCTS 730-1-000000-061007 is a 90-degree duct boot designed to transition airflow from a rectangular duct run to a floor, wall, or ceiling register opening. This sheet metal fitting redirects conditioned air at a right angle, allowing the supply duct system to terminate at a register grille in a finished space. The size designation of 6 x 10 x 7 inches identifies the inlet and outlet dimensions, making it a standard component in residential and light commercial forced-air HVAC systems. HVAC installers and sheet metal contractors select this type of boot during new construction rough-in or when replacing damaged or undersized existing boots.

This 90-degree duct boot is suited for forced-air supply systems where a duct run must change direction at the point of termination. Typical applications include floor register installations in residential construction, wall boot installations in baseboard or low-sidewall configurations, and ceiling drop installations. The 6 x 10 x 7 inch size designation reflects a common residential supply opening size and is used to match the boot to both the upstream rectangular duct and the downstream register or grille frame dimensions. Confirm that the inlet, outlet, and offset dimensions match your existing layout before installation.

Key Features

• 90-degree configuration redirects airflow from horizontal duct run to register opening
• Size designation 6 x 10 x 7 inches suits common residential supply register openings
• Sold as a single unit for targeted replacement or new construction use
• Compatible with standard rectangular duct systems used in forced-air HVAC applications

Compatibility

Designed as an OEM-style replacement or new-installation fitting for residential and light commercial forced-air supply duct systems using rectangular ductwork. Verify inlet and outlet dimensions against your existing register opening and upstream duct size before ordering.

Installation Notes

Installation is typically performed by a licensed HVAC technician or sheet metal contractor. Power down the air handler or furnace and close the system damper before removing an existing boot. The boot should be secured to the duct with sheet metal screws and sealed at all joints with UL-listed duct sealant or metal-backed tape per applicable mechanical codes. Do not use standard cloth-backed duct tape as a primary sealant.