Air Flow Products 720-1-000000-061007 End Boot 6x10x7

Product Description

The AIR FLOW PRODUCTS 720-1-000000-061007 is an end boot fitting used in residential and light commercial forced-air duct systems. End boots serve as the transition point between the branch duct run and the floor, wall, or ceiling register. This unit carries a 6 x 10 x 7 inch size designation, making it a common choice for standard rectangular register openings. HVAC installers and sheet metal contractors select end boots during new construction and retrofit duct work to complete the supply or return air distribution system and ensure a flush register fit.

This end boot is suited for installation in residential forced-air systems where a rectangular duct run terminates at a wall, floor, or ceiling register. The 6 x 10 x 7 inch sizing corresponds to duct inlet and register opening dimensions that appear frequently in single-family and light commercial construction. Verify the duct inlet size, the register rough-in opening, and the offset depth against the 6 x 10 x 7 inch designation before installation. The unit is sold individually.

Key Features

• End boot configuration transitions a rectangular duct run to a register opening
• 6 x 10 x 7 inch size designation fits common residential register rough-in openings
• Sold as a single unit for precise quantity ordering
• Designed for use in forced-air supply and return duct systems

Compatibility

Designed as an OEM-style replacement or new-construction fitting for residential and light commercial forced-air duct systems requiring a 6 x 10 x 7 inch end boot configuration.

Installation Notes

End boots are typically installed by licensed HVAC technicians or sheet metal contractors following SMACNA duct construction standards. Turn off the air handling system before connecting or modifying any duct section. Secure the boot to the branch duct with appropriate sheet metal screws and seal all joints with listed duct sealant or metal tape per local mechanical code requirements. Confirm register opening dimensions and duct centerline offset match the boot designation before securing the unit in place.