Advanced Cable Ties AL-21-50-0-C Uv Black Nylon Cable Tie

Product Description

The ADVANCED CABLE TIES AL-21-50-0-C is a UV-stabilized black nylon cable tie designed for bundling and securing wire harnesses, conduit, hose assemblies, and similar components in both indoor and outdoor installations. Measuring 21.62 inches in length and 0.185 inches in width, it delivers a 50 lb tensile strength rating with a 3-tooth pawl locking mechanism that holds firmly under vibration and load. Constructed from Nylon 6/6, it handles a temperature range of -40 to 185 degrees F, making it suitable for harsh environments where standard ties fail. Each pack contains 100 ties.

This cable tie is used across HVAC, electrical, plumbing, and general industrial applications wherever long-length bundling is required. The 21.62-inch length accommodates bundle diameters from 0.118 inches up to 6.3 inches, covering a wide range of hose, wire, and conduit bundle sizes. Its UV resistance makes it a practical choice for rooftop equipment, outdoor conduit runs, exterior mechanical panels, and exposed service installations where sunlight degradation is a concern.

Key Features

• 50 lb tensile strength with 3-tooth pawl locking mechanism for secure, vibration-resistant hold
• UV-stabilized Nylon 6/6 construction rated for indoor and outdoor use
• Temperature range of -40 to 185 degrees F for use in extreme heat and cold
• Accommodates bundle diameters from 0.118 to 6.3 inches
• 21.62-inch length suits large-diameter bundles and long-span lacing applications
• 100 ties per pack for jobsite and service van stocking

Compatibility

Designed as a standard-duty cable tie for general wire management, bundling, and securing applications across residential and commercial HVAC, electrical, and plumbing installations.

Installation Notes

Cable ties of this type are installed by electricians, HVAC technicians, and plumbers as part of rough-in and service work. De-energize any electrical circuits before securing wire bundles near live conductors. Trim the tail flush with the locking head after cinching to prevent sharp edges that can cause hand injuries during service. Follow NEC bundling and securing guidelines when used on electrical conductors or raceways.