3M 7010359910 Type 27 Grinding Wheel 7in 36 Grit Ceramic

Product Description

The 3M 7010359910 is a Type 27 depressed center grinding wheel designed for aggressive material removal in metalworking and fabrication applications. Built with a ceramic abrasive grain and resinoid bond, this wheel delivers a very coarse 36-grit cut rated up to 8,500 RPM. The 7-inch diameter and 1/8-inch thickness make it well suited for flat and contoured surface grinding where the depressed center profile allows flush work against the material. It is installed and used by metalworkers, fabricators, pipefitters, and ironworkers running angle grinders on the job site or in the shop.

This wheel is intended for use with a standard angle grinder equipped with a 5/8-11 threaded spindle. The very coarse 36-grit ceramic abrasive is appropriate for weld grinding, surface conditioning, bevel prep, and stock removal on ferrous and hard metals. The Type 27 depressed center profile keeps the wheel body below the plane of the guard, allowing the operator to work close to fixtures, flanges, and structural members without interference.

Key Features

• Type 27 depressed center profile for flush grinding close to obstructions
• Ceramic abrasive grain provides aggressive stock removal at 36 grit very coarse grade
• Resinoid bond construction for durability under high-load grinding conditions
• Rated to 8,500 RPM maximum for use with standard angle grinders
• 5/8-11 threaded center hole for direct mount to standard angle grinder spindles
• 7-inch diameter by 1/8-inch thickness for a balance of coverage and wheel life

Compatibility

Designed for use with angle grinders equipped with a 5/8-11 threaded spindle arbor. Verify that the grinder's no-load RPM rating does not exceed the 8,500 RPM maximum marked on the wheel before mounting.

Installation Notes

Installation and operation of grinding wheels should be performed by qualified personnel following ANSI B7.1 safety standards for the use, care, and protection of abrasive wheels. Always disconnect power or remove the battery from the angle grinder before mounting or removing a wheel. Inspect the wheel for cracks or damage before each use and never operate above the maximum rated RPM. A compatible wheel guard must remain in place during all grinding operations.