3M 7010319502 Female Wire Disconnect 12-10 Awg 50 Pack

Product Description

The 3M 7010319502 is a fully insulated female wire disconnect designed for secure, tool-free electrical connections in a wide range of wiring applications. Constructed with a nylon insulation jacket in yellow, this disconnect accepts 12-10 AWG wire and features a 1/4 inch tab width for reliable push-on termination. The yellow color coding follows standard industry convention for 12-10 AWG conductors, making polarity and gauge identification fast during installation. Electricians, HVAC technicians, and other trade professionals use these disconnects when making quick-disconnect terminations on control boards, motor leads, and other low-voltage or line-voltage wiring points.

This disconnect is suited for residential and light commercial electrical work, HVAC control wiring, appliance wiring, and automotive or panel wiring where a removable push-on female terminal is required. The 1/4 inch tab size is a common standard fitting found on spade terminals throughout HVAC equipment, motors, and control components. Each package contains 50 pieces, making this a practical shop or service-van supply quantity for ongoing wiring work.

Key Features

• Fully insulated nylon jacket provides electrical isolation and mechanical protection at the termination point
• Accepts 12-10 AWG wire for compatibility with common branch and equipment wiring sizes
• 1/4 inch tab width fits standard spade terminals found on motors, switches, and control boards
• Yellow color coding provides quick visual identification of the 12-10 AWG wire range
• Female push-on design allows for clean, removable connections without soldering
• Package of 50 pieces supports recurring field or shop use

Compatibility

Designed for use with 12-10 AWG conductors and 1/4 inch male spade tab terminals common in residential and commercial electrical, HVAC, and appliance wiring applications.

Installation Notes

Installation is performed by licensed electricians or qualified HVAC technicians following applicable NEC requirements. Always de-energize the circuit and verify absence of voltage before terminating or removing wire disconnects. Use a calibrated wire stripper and the appropriate crimping tool rated for insulated disconnect terminals to ensure a secure, low-resistance crimp. Do not over-strip the conductor or attempt to re-crimp a terminal that has already been seated.