3M 7000124900 Masking Tape 4 in 60 Yd Green

Product Description

The 3M 7000124900 is a green crepe paper masking tape built for demanding paint masking, bundling, holding, and surface protection tasks. It measures 4 inches wide and 60 yards long with a 6.7 mil thickness, giving it the body to conform around curves and irregular surfaces without lifting or flagging. The rubber adhesive delivers a tensile strength of 25 lb/in, holding firmly through spray, bake, and wipe-down cycles. It withstands temperatures up to 250 degrees F for 30 minutes, making it well-suited for automotive refinishing and industrial paint operations where parts pass through a bake oven. Licensed HVAC, auto body, and general trade technicians rely on this tape for clean lines and residue-free removal after bake.

This tape is used in automotive body shops, manufacturing facilities, and general industrial settings where a reliable paint masking tape must handle heat, solvents, and UV exposure without bleeding or curling. It applies cleanly to metal, glass, and rigid plastic surfaces and is appropriate for both interior and exterior masking prior to spray or powder-coat operations. The 4-inch width makes it efficient for masking wide body panels or large flat surfaces in a single pass. It is also used for bundling components and protecting finished surfaces during fabrication and transport.

Key Features

• Removes cleanly after baking at temperatures up to 250 degrees F for 30 minutes
• Rubber adhesive with 25 lb/in tensile strength resists lifting and curling during application
• Adhesive transfer-resistant formula leaves no residue on most surfaces at rated bake temperature
• Solvent-resistant, moisture-resistant, and UV-resistant for indoor and outdoor masking jobs
• Conformable green crepe paper construction follows contours and curved body lines
• 4-inch width covers wide panels efficiently; 60-yard roll reduces changeovers on large jobs

Compatibility

Part of the 3M 401+/233+ series. Designed for paint masking on metal, glass, and rigid plastic surfaces in automotive refinishing, general industrial painting, and manufacturing applications. Note: removal from surfaces such as EPDM rubber moldings is difficult; confirm substrate compatibility before use.

Installation Notes

Applied by hand or with a standard tape dispenser; no special tools required. Surface must be clean, dry, and free of oils or loose particles before tape is applied to ensure proper adhesion and clean removal. Remove tape promptly after the bake or cure cycle while the part is still warm to reduce the risk of adhesive transfer. Do not exceed the rated 250 degrees F bake temperature or 30-minute bake duration.