3M 7000119115 Groove Pin Type E Replacement Part

Product Description

The 3M 7000119115 is a Type E groove pin measuring 1/8 inches in diameter by 7/8 inches in length, designed as a genuine replacement component for 3M pneumatic and electric power tools. Groove pins of this type secure internal assemblies and maintain precise alignment between moving parts under continuous rotational load. This pin is sold individually and is intended for use by technicians performing scheduled maintenance or field repairs on 3M tool platforms. Its small profile and standard Type E groove pattern allow for straightforward press-fit installation with common hand tools.

This groove pin is a direct replacement part for 3M disc sanders, die grinders, and cut-off wheel tools. It is suited for light industrial, automotive, and fabrication shop environments where these tools are in regular service. Technicians maintaining a fleet of 3M pneumatic or electric grinders will find this pin listed in the applicable owner's manual parts list and schematic. It is sold as a single unit, making it practical for targeted repairs without overstocking hardware.

Key Features

• Type E groove pin profile for secure press-fit retention in 3M tool assemblies
• Nominal dimensions of 1/8 inches diameter by 7/8 inches length
• Sold individually, allowing single-unit replacement without excess inventory
• Listed in 3M owner's manual parts schematics for compatible tools
• Designed for use in disc sanders, die grinders, and cut-off wheel tools

Compatibility

Compatible with 3M disc sanders, die grinders, and cut-off wheel tools where a Type E groove pin is specified. Refer to the tool's owner's manual parts list and schematic to confirm this pin is the correct replacement for your specific model before installation.

Installation Notes

Installation and replacement of internal tool components should be performed by a qualified technician familiar with pneumatic or electric power tool service procedures. Disconnect the tool from its air supply or power source completely before disassembling any part of the housing or internal mechanism. A pin punch and small mallet or an arbor press are typical tools used for groove pin removal and installation. Consult the 3M owner's manual parts schematic to verify correct pin orientation and seating depth before reassembling the tool.

Technical Specifications

• Pin Type: Type E Groove Pin
• Diameter: 1/8 inches
• Length: 7/8 inches
• Unit of Measure: Each
• Minimum Order Quantity: 1
• UPC: 50051115065595

Standard Information

• Brand: 3M
• Manufacturer Part Number: 7000119115