3M 7000051822 Bumpon SJ5007 White Self-adhesive Rubber Bumper

Product Description

The 3M 7000051822 is a self-adhesive rubber bumper from the Bumpon Protective Products line, model SJ5007, in white. It measures 0.413 inches wide by 0.100 inches high and features a flat top shape that increases load-bearing capacity and improves wear resistance compared to rounded-profile bumpers. The pressure-sensitive adhesive backing bonds to most clean, dry surfaces without fasteners or tools. This bumper is used as feet, stops, and spacers across a wide range of equipment, enclosures, and assemblies. Installation requires no special trade certification and is appropriate for general equipment assembly, panel fabrication, and field-service technicians working across HVAC, electrical, and mechanical trades.

The SJ5007 is suited for residential and commercial applications where surface protection, vibration dampening, or controlled spacing is needed. Typical uses include mounting under electronic enclosures, control panels, junction boxes, and equipment housings to prevent surface contact, reduce sliding, and absorb minor impact. The flat top profile distributes load evenly, making it appropriate for components that bear downward pressure or experience repeated contact. It is commonly applied during final assembly or as a field retrofit on installed equipment.

Key Features

• Flat top profile increases load-bearing capacity and wear resistance over dome-style bumpers
• Self-adhesive backing bonds without fasteners, adhesives, or tools
• Low profile at 0.100 inches high minimizes clearance impact
• 0.413 inch width suitable for small equipment feet, panel stops, and spacer applications
• White finish for use on light-colored surfaces and enclosures

Compatibility

Designed as an OEM-style protective bumper suitable for general use as feet, stops, and spacers on equipment panels, enclosures, and assemblies where a low-profile, flat-top rubber bumper is required.

Installation Notes

Clean and dry the mounting surface thoroughly before applying the adhesive backing for maximum bond strength. Power down or de-energize any equipment before applying bumpers near electrical components or terminals. No special tools, fasteners, or trade licensing are required for installation. Allow adequate dwell time after application before subjecting the bumper to load or vibration.