Magnasphere Corp MSS-310S-GO Surface Mount Contact Switch

Product Description

The MAGNASPHERE CORP MSS-310S-GO is a surface-mount security contact switch designed for special application contact installations. It houses one switch and one closed loop in a single unit, making it suited for perimeter protection and door or window monitoring in security and access control systems. The surface-mount form factor simplifies installation on a wide range of frame and door materials without requiring mortising or routing. This type of device is typically installed by licensed alarm technicians, security system integrators, or electricians performing low-voltage work on commercial or residential security panels.

The MSS-310S-GO is used in special application contact scenarios where standard reed-switch contacts may not provide adequate tamper resistance or positional accuracy. Its single-switch, single-closed-loop configuration fits installations requiring a clean, discrete circuit output to a security control panel. Typical applications include door and window contacts in commercial facilities, access control entry points, and perimeter alarm zones where surface mounting is preferred or required by the installation layout.

Key Features

• Surface-mount design installs directly onto door frames, window frames, or wall surfaces without mortising
• Single switch and single closed loop configuration for straightforward zone wiring
• Classified under special application contacts for installations requiring non-standard contact solutions
• Sold as a single unit (EA) for per-point installations

Compatibility

Designed as an OEM-style surface-mount contact switch for special application security and access control installations where a single-switch, single-closed-loop circuit output is required.

Installation Notes

Installation should be performed by a qualified low-voltage technician or licensed alarm installer in accordance with local codes and the manufacturer product manual. Disconnect and de-energize the security control panel zone circuit before wiring the switch. Verify loop continuity with a multimeter after installation before restoring panel power. Follow the manufacturer product manual for mounting orientation and gap tolerances specific to this switch series.