Gilmour 881154-1001 Garden Hose Rack 100ft Steel

Product Description

The GILMOUR 881154-1001 is a wall-mounted steel garden hose rack designed to store and organize garden hoses up to 100 feet in length. The rack uses a keyhole slot mounting pattern, which allows a single installer to hang the unit quickly without holding it in place while driving fasteners. Built from steel construction, it provides durable support for a fully loaded hose. This type of hose storage hardware is typically installed by homeowners, groundskeepers, and irrigation technicians as part of an organized outdoor water management setup.

This hose rack suits residential and light commercial exterior wall applications where a permanent, wall-mounted storage solution is preferred over a freestanding reel. It is appropriate for use on wood siding, masonry, and similar exterior surfaces when paired with the correct fasteners for the substrate. The keyhole design makes seasonal removal and reinstallation straightforward, which is practical in climates where hoses are brought indoors during winter months.

Key Features

• Keyhole mounting slots allow fast single-person installation and easy removal
• Steel construction provides rigid support for hoses up to 100 feet
• Compact footprint at 10.75 inches wide, 8.5 inches tall, and 7.5 inches deep
• Lightweight at 1.2 pounds for straightforward handling during installation
• Sold as a single unit with no minimum quantity requirement beyond one

Compatibility

Designed as a wall-mounted storage solution compatible with standard garden hoses up to 100 feet in length.

Installation Notes

Installation is typically performed with basic hand tools including a drill, level, and appropriate wall anchors for the mounting surface. Power down any nearby low-voltage irrigation controllers before working in the immediate area if electrical lines are routed along the same wall section. Select fasteners rated for the substrate material — use masonry anchors for brick or concrete and wood screws for framed walls. Do not overtighten fasteners through the keyhole slots, as this can distort the mounting flange.