Abb UA9AKB-CTN Pvc Sch 40 90 Degree Elbow 2.5 Inches

Product Description

The ABB INSTALLATION PRODUCTS UA9AKB-CTN is a 2.5-inch Schedule 40 PVC 90-degree belled end elbow with a standard radius sweep. This fitting redirects conduit or piping runs at a right angle while maintaining full Schedule 40 wall thickness throughout the bend. The belled end design accepts standard-diameter pipe or conduit directly, eliminating the need for a separate coupling at one end. Licensed electricians, plumbers, and pipefitters install this type of fitting in both underground and above-grade applications where rigid PVC conduit or Schedule 40 pipe systems require a 90-degree direction change.

This elbow is suited for residential and commercial electrical conduit installations, irrigation systems, and general-purpose PVC piping runs. The 2.5-inch nominal size accommodates the corresponding Schedule 40 pipe or conduit diameter. Standard radius geometry is appropriate for pulling wire through electrical conduit or for low-velocity fluid flow applications. It is sold in a package of 6 units, making it practical for contractors completing multi-run installations.

Key Features

• 2.5-inch nominal size fits Schedule 40 PVC pipe and conduit of the same diameter
• 90-degree standard radius bend for right-angle direction changes
• Belled end design accepts pipe directly without a separate coupling
• Schedule 40 wall thickness provides consistent pressure and impact rating through the elbow body
• PVC construction is corrosion-resistant and compatible with common PVC solvent cements
• Packaged in quantities of 6 for multi-unit job-site efficiency

Compatibility

Designed as an OEM-style replacement and standard fitting for 2.5-inch Schedule 40 PVC conduit and piping systems installed per applicable electrical and plumbing codes.

Installation Notes

Installation is performed by licensed electricians or plumbers depending on the application. De-energize any circuit and isolate fluid flow before cutting into an existing run. Solvent-cement joints per the fitting and cement manufacturer instructions, and allow full cure time before restoring pressure or pulling wire. Reference NEC Article 352 for PVC conduit installations or the applicable IPC section for pressure piping.

Technical Specifications

• Nominal Size: 2.5 inches
• Schedule: 40
• Bend Angle: 90 degrees
• Radius Type: Standard
• End Type: Belled End
• Material: PVC
• Package Quantity: 6 each
• Weight: 15.97 pounds

Standard Information

• Brand: ABB INSTALLATION PRODUCTS
• Manufacturer Part Number: UA9AKB-CTN