Abb UA7AJB-CAR Pvc Sch40 45 Degree Bell End Elbow 2 Inches

Product Description

The ABB INSTALLATION PRODUCTS UA7AJB-CAR is a 2-inch Schedule 40 PVC 45-degree bell end elbow rated for standard-radius directional changes in rigid conduit and piping systems. The bell end socket design accepts standard Schedule 40 PVC pipe or conduit for a secure, solvent-weld joint. At 3.44 pounds per unit, the fitting is dimensionally consistent with industry-standard Schedule 40 fittings. Electricians and plumbers install this type of elbow when routing conduit or pipe at a 45-degree offset through walls, ceilings, and underground runs where a gradual change in direction is required.

This elbow is suited for residential and light commercial electrical conduit installations as well as plumbing drain, waste, and vent applications where Schedule 40 PVC is the specified material. The 45-degree geometry is commonly used in conduit bodies, underground stub-ups, and horizontal-to-angled transitions. The standard-radius design keeps wire pull tension within acceptable limits on electrical conduit runs and maintains adequate flow characteristics on plumbing lines.

Key Features

• 2-inch nominal size fits standard Schedule 40 PVC pipe and conduit
• 45-degree angle for gradual directional changes with lower pull tension than 90-degree fittings
• Bell end socket design accepts solvent-weld bonding for a permanent, leak-resistant joint
• Schedule 40 wall thickness for full compatibility with Sch40 system components
• Standard radius geometry suitable for both conduit and plumbing applications
• Sold in a package quantity of 4 units

Compatibility

Designed as an OEM-style replacement and standard-use fitting compatible with 2-inch Schedule 40 PVC pipe and conduit systems.

Installation Notes

Installation should be performed by a licensed electrician or plumber in accordance with applicable NEC, IPC, or local code requirements. Shut off all power or isolate the piping system before cutting into an existing line. Use an approved PVC solvent cement and primer on all bell end joints; allow full cure time before pressurizing or pulling wire. Do not apply heat or mechanical stress to the fitting during or after bonding.

Technical Specifications

• Nominal Size: 2 inches
• Schedule: 40
• Angle: 45 degrees
• End Type: Bell End Socket
• Radius Type: Standard Radius
• Material: PVC
• Weight: 3.44 pounds
• Package Quantity: 4 units

Standard Information

• Brand: ABB INSTALLATION PRODUCTS
• Manufacturer Part Number: UA7AJB-CAR