Abb a1200hs20pg Steel Strut Channel 12 Gauge 20 Ft Pre-galvanized

Product Description

The ABB INSTALLATION PRODUCTS a1200hs20pg is a half-slotted steel strut channel used in structural support and framing applications across commercial and industrial installations. Manufactured from 12-gauge pre-galvanized steel, the channel measures 1-5/8 inches wide by 1-5/8 inches deep and comes in a 20-foot length. The half-slotted configuration features 9/16-inch by 1-1/8-inch slots on 2-inch centers, allowing standard strut hardware to engage at consistent intervals. Electricians, mechanical contractors, and plumbers use this channel to hang conduit, pipe, ductwork, and equipment in a wide range of building systems.

This strut channel is suited for residential, commercial, and industrial support and framing applications. It is designed to reduce installation labor by maximizing the number of framing configurations achievable with a minimum number of components. Typical uses include overhead conduit runs, pipe hangers, trapeze assemblies, seismic bracing support structures, and equipment mounting in mechanical rooms and utility spaces. The pre-galvanized finish provides baseline corrosion resistance for interior and protected exterior environments.

Key Features

• 12-gauge pre-galvanized steel construction for durability and corrosion resistance
• Half-slotted profile with 9/16-inch by 1-1/8-inch slots on 2-inch centers for consistent hardware engagement
• 1-5/8-inch by 1-5/8-inch cross-section — standard strut sizing compatible with common strut hardware
• 20-foot length reduces the number of splices needed on longer runs
• Designed to support a maximum number of framing configurations with minimal components and labor

Compatibility

Designed as an OEM-style replacement and standard-stock strut channel for use with conventional 1-5/8-inch strut hardware, fittings, and accessories in structural support and framing assemblies.

Installation Notes

Installation is typically performed by licensed electricians, mechanical contractors, or plumbers depending on the supported system. Cut channel to length using a metal-cutting saw or angle grinder and deburr cut ends before handling. Verify that all hardware, beam clamps, and fasteners are rated for the intended load before finalizing the assembly. Follow applicable NEC, IPC, or IFGC guidelines for support spacing requirements based on the system being hung.