Wiha 74350 Power Screwdriver Bit 2 in 10 Piece Standard Hex

Product Description

The WIHA 74350 is a 10-piece set of power screwdriver bits engineered for use with power drivers and impact-rated tooling in trade and industrial applications. Each bit measures 2 inches in overall length and is manufactured from steel for durability under rotational load. The 5 mm standard hex shank seats securely in quick-change chucks and bit holders without magnetic retention, making it straightforward to swap bits during high-volume fastening work. This set is a go-to option for electricians, HVAC technicians, plumbers, and general contractors who rely on powered fastening in daily service calls or installations.

The 74350 is suited for residential and light commercial jobsite use where a consistent, non-magnetic power bit is preferred. The 2-inch length provides clearance in recessed or obstructed fastening locations without adding excessive extension. The standard hex drive format is compatible with the wide range of quick-change bit holders and power screwdrivers common in the trades. Ten bits per package supports extended use between resupply, making this set practical for tool pouches and service vans.

Key Features

• Steel construction for durability under repeated power-drive cycles
• 2-inch overall length suits recessed and standard fastening applications
• 5 mm standard hex shank fits common quick-change bit holders and chucks
• Non-magnetic design eliminates unintended fastener retention
• 10 bits per package for extended jobsite availability
• Minimum order quantity of 1 package for flexible procurement

Compatibility

Designed for use with power screwdrivers and quick-change bit holders accepting a 5 mm standard hex shank drive in power bit applications.

Installation Notes

Insert the hex shank fully into the bit holder or chuck before applying power to ensure a secure seat and prevent bit walkout. Confirm the driver is set to the appropriate torque clutch setting for the fastener and material being driven. Inspect bits regularly for tip wear or deformation and replace before wear causes cam-out damage to fastener heads. Dispose of worn bits properly and keep spare sets on hand to avoid jobsite delays.