Wiha 32531 Insulated Torx Driver T10 1000V

Product Description

The WIHA 32531 is a T10 insulated Torx driver rated for 1000 volts, designed for electricians and service technicians working on energized equipment or in environments where accidental contact with live circuits is a risk. The driver features a 2.375-inch blade and a 4.09-inch standard handle, bringing the overall length to 6.5 inches. The handle diameter measures 0.91 inches for a secure grip. This is a hand tool intended for driving and removing T10 Torx fasteners in electrical panels, control boards, and similar assemblies where insulation protection is required by code or best practice.

The WIHA 32531 is suited for residential and commercial electrical work, HVAC control panel service, and any application where T10 Torx fasteners are used near live voltage. The 1000V insulation rating makes it appropriate for use in environments governed by NFPA 70E arc flash and shock hazard protocols. Electricians, HVAC technicians, and industrial maintenance professionals typically carry this driver as part of an insulated hand tool set.

Key Features

• 1000V insulated construction for protection against electrical shock during live-circuit service
• T10 Torx tip for standard Torx fasteners found in control boards and electrical assemblies
• 6.5-inch overall length with a 2.375-inch blade for access in confined spaces
• 4.09-inch standard handle with 0.91-inch diameter for controlled torque application
• Not tether capable — intended for standard hand-tool use in controlled work areas

Compatibility

Designed for use with standard T10 Torx fasteners. Compatible with any application requiring a T10 insulated Torx driver where 1000V-rated hand tools are specified.

Installation Notes

This tool is intended for use by qualified electricians and technicians trained in electrical safety procedures. Always follow NFPA 70E guidelines and de-energize equipment whenever possible before service; use insulated tools as a secondary protective measure, not a substitute for lockout/tagout procedures. Inspect the insulation coating for cracks or damage before each use and remove the tool from service if the insulation is compromised.