Wiha 32516 Insulated Torx Driver T7 6.5 in Oal

Product Description

The WIHA 32516 is an insulated Torx driver sized for T7 fasteners, built for electricians and other trade professionals working on live or potentially energized equipment. The driver features a 6.5-inch overall length with a 2.375-inch blade and a standard handle measuring 0.91 inches in diameter and 4.09 inches in length. It meets ASTM F1505-10, EN/IEC 60900, NFPA 70E, and VDE 0682/Part 201 insulation standards, making it a code-recognized tool for 1000-volt-rated work. At 0.06 pounds, it is light enough for extended use in panel work, motor terminations, or precision electronic assemblies where T7 drive heads are common.

This driver is suited for residential and commercial electrical work where insulated hand tools are required or preferred. Typical applications include panel board service, low-voltage control wiring, motor control centers, and electronic equipment repair. The T7 Torx profile is common in small electronic assemblies and certain HVAC control components. It is appropriate wherever NFPA 70E arc-flash or shock-hazard protocols require insulated tooling.

Key Features

• Insulated to ASTM F1505-10, EN/IEC 60900, NFPA 70E, and VDE 0682/Part 201 for 1000-volt-rated applications
• T7 Torx end type for precision fasteners in electronic and control assemblies
• 6.5-inch overall length with a 2.375-inch blade for access in confined spaces
• Standard handle at 0.91 inches diameter and 4.09 inches length for controlled grip torque
• Lightweight at 0.06 pounds for reduced hand fatigue during extended service calls
• Not tether capable — note when working at height or in overhead applications

Compatibility

Designed as a standard T7 Torx driver replacement or addition for insulated hand tool sets used in electrical, HVAC control, and low-voltage service work requiring code-compliant insulated tooling.

Installation Notes

This tool is installed and used by licensed electricians and technicians performing work on energized or potentially energized equipment. Even with a VDE- and IEC-rated insulated driver, always follow NFPA 70E procedures including appropriate arc-flash PPE and lockout/tagout protocols where de-energization is required. Inspect the insulation sleeve for cracks or damage before each use — a compromised sleeve negates the insulation rating. Do not use this driver as a pry tool or apply side-loading force to the blade.