Wiha 28530 T10 Torx Torque Blade Bit 8.75 in 1/8 Hex

Product Description

The WIHA 28530 is a T10 Torx torque blade screwdriver bit designed for precision fastening in applications where controlled torque is critical. The bit measures 8.75 inches in overall length and features a 1/8 inch hex shank for compatibility with standard bit holders and handles. At 0.07 pounds, it is lightweight enough for extended use without fatigue. WIHA manufactures this bit for technicians who require accurate, repeatable torque output when driving Torx fasteners in tight or sensitive assemblies. It is sold individually and suits professionals working in electronics, HVAC controls, appliance service, and similar trades where small Torx fasteners are common.

The WIHA 28530 T10 torque blade bit is well suited for residential and light commercial service work involving control boards, electrical enclosures, appliance panels, and other assemblies secured with T10 Torx fasteners. The extended 8.75 inch length provides reach into deeper cavities without requiring a full-length driver. Technicians in HVAC, electrical, and appliance service trades will find this bit a practical addition to a precision tool kit where standard Phillips or slotted bits are not appropriate.

Key Features

• T10 Torx drive for secure engagement with matching fastener heads
• 8.75 inch overall length for extended reach in confined assemblies
• 1/8 inch hex shank fits standard bit holders, handles, and driver chucks
• Torque blade design supports controlled, repeatable torque application
• Lightweight at 0.07 pounds for reduced hand fatigue during repetitive work
• Sold individually with a minimum order quantity of one

Compatibility

Designed for use with standard 1/8 inch hex bit holders and handles that accept Torx screwdriver bits.

Installation Notes

Insert the 1/8 inch hex shank fully into the bit holder or handle before applying torque to prevent cam-out or shank slippage. De-energize and lock out electrical equipment before driving or removing fasteners on control boards or electrical enclosures, following applicable NEC guidelines. Use the appropriate T10 Torx size to avoid stripping fastener heads. Inspect the bit tip for wear before each use and replace if the drive surfaces show rounding or damage.