West Penn Wire D4852GY1000 Shielded Cable 24AWG 2C Cmr

Product Description

The WEST PENN WIRE D4852GY1000 is a shielded, stranded, 24 AWG 2-conductor multimedia cable rated CMR (riser) and finished in gray, supplied in a 1000-foot quantity. CMR-rated cable is listed for vertical runs in commercial and multi-story buildings, meeting the fire-propagation requirements for riser applications under the National Electrical Code. The stranded conductors allow flexibility during routing and termination. Shielding reduces interference in low-voltage signal runs, making this cable well suited for structured cabling, audio, and control wiring where signal integrity is a priority. Electricians and low-voltage cabling technicians are the primary installers of this product.

This cable is used in commercial and residential structured wiring installations where a shielded, riser-rated 2-conductor cable is required. Typical applications include intercom wiring, low-voltage control circuits, audio distribution, and similar multimedia signal runs. It is appropriate for indoor vertical riser pathways in office buildings, hospitality facilities, schools, and multi-unit residential construction. The 1000-foot put-up is sized for full-building runs and reduces splice points across long cable paths.

Key Features

• 24 AWG stranded conductors for flexibility during installation and termination
• 2-conductor configuration for standard signal and control pair wiring
• Overall shield reduces electromagnetic and radio-frequency interference on signal runs
• CMR riser rating meets NEC requirements for vertical riser installation in commercial buildings
• Gray jacket for standard low-voltage identification in structured cabling environments
• 1000-foot continuous put-up minimizes mid-run splices on long cable paths

Compatibility

Designed for use in indoor riser applications requiring a shielded 24 AWG 2-conductor CMR-rated multimedia cable, compatible with standard low-voltage termination hardware, punch-down blocks, and connectors sized for 24 AWG conductors.

Installation Notes

Installation should be performed by a licensed electrician or qualified low-voltage cabling technician in accordance with NEC Article 800 and local jurisdiction requirements. De-energize any connected equipment before terminating or splicing cable runs. CMR-rated cable is approved for riser pathways but is not rated for plenum spaces — verify the installation environment before pulling cable. Maintain minimum bend radius during routing to avoid damaging the shield or conductor insulation.