West Penn Wire CN-CSM2XMF-50 Xlr Mic Cable 50 Feet

Product Description

The WEST PENN WIRE CN-CSM2XMF-50 is a 50-foot XLR male-to-female microphone cable assembly built for professional audio interconnect applications. This pre-terminated cable ships as a complete, ready-to-install assembly, eliminating field termination time on the job. It is designed for balanced audio signal transmission between microphones, mixers, amplifiers, and other XLR-equipped equipment. Audio installation technicians, AV integrators, and sound contractors rely on this type of interconnect for clean, low-noise signal runs in permanent and semi-permanent installations.

This cable assembly is suited for use in commercial audio installations, houses of worship, performance venues, conference rooms, and broadcast environments. The 50-foot length covers typical stage-to-mixer or wall-panel-to-rack runs without requiring field splicing or custom termination. It is sold as a single unit and falls within the interconnect cable category, making it appropriate for both new installations and replacement of worn or damaged runs.

Key Features

• 50-foot overall cable length for extended microphone and line-level signal runs
• XLR male to XLR female configuration supports standard balanced audio connections
• Pre-terminated assembly reduces installation time and eliminates field soldering
• Balanced wiring configuration provides common-mode noise rejection in professional audio systems
• Sold individually as a complete, ready-to-deploy interconnect assembly

Compatibility

Designed as a standard XLR balanced interconnect cable compatible with any equipment using 3-pin XLR connectors, including microphones, direct boxes, mixers, signal processors, and powered speakers.

Installation Notes

Installation is performed by AV technicians or low-voltage contractors following applicable local codes and AVIXA best practices for signal cable routing. Route away from AC power conductors and high-voltage lines to prevent induced hum or interference in the audio signal. Secure cable runs with appropriate cable management hardware and avoid sharp bends or kinks that can damage internal conductors. No special tools beyond standard cable management hardware are required for deployment of a pre-terminated assembly.