West Penn Wire BP251822B1000 Access Control Cable 18AWG 1000ft

Product Description

The WEST PENN WIRE BP251822B1000 is an 18 AWG, 22-conductor stranded unshielded plain access control cable supplied on a 1000-foot spool. This cable is designed for low-voltage access control, security, and alarm wiring applications where multiple conductors are needed between panels, readers, door hardware, and control equipment. The stranded construction provides flexibility during pull-through and termination, and the plain jacket finish suits typical conduit or plenum-alternative routing where a non-shielded cable meets the system specification. Security and low-voltage electricians are the primary installers.

This cable is used in commercial and residential security installations including door access control systems, proximity card reader wiring, electric strike and magnetic lock circuits, alarm panels, and intercom wiring runs. The 1000-foot length makes it practical for new construction pulls or large retrofit projects where multiple runs are needed from a single spool. It is appropriate for in-wall, in-conduit, or bundled low-voltage applications consistent with the cable rating and local code requirements.

Key Features

• 22-conductor configuration supports complex multi-point access control wiring in a single cable run
• 18 AWG stranded conductors provide flexibility for routing through conduit and around corners
• Unshielded plain construction keeps cost and diameter low where EMI shielding is not required
• 1000-foot spool length reduces splices and supports long commercial runs
• Low-voltage rated for use with access control panels, card readers, and security devices

Compatibility

Designed as a general-purpose stranded unshielded access control and security cable suitable for use with low-voltage access control panels, alarm systems, and related security equipment that specify 18 AWG multi-conductor unshielded wiring.

Installation Notes

Installation should be performed by a licensed low-voltage or security systems technician in accordance with NEC Article 725 for Class 2 and Class 3 remote-control and signaling circuits. De-energize all connected control panels and access control hardware before terminating conductors. Avoid running this unshielded cable in parallel with high-voltage power conductors for extended distances, as this can introduce noise into sensitive access control circuits. Verify local authority having jurisdiction requirements for cable type, conduit fill, and any plenum-rating needs before installation.