Wera 05134930001 PH1 Phillips Power Bit 1/4 in Hex 2 in

Product Description

The WERA 05134930001 is a PH1 Phillips power screwdriver bit designed for use with power tools and impact-rated bit holders equipped with a 1/4 inch hex drive. Built to a 2 inch overall length and 4.50 mm body diameter, this bit delivers consistent drive engagement in Phillips fasteners across a wide range of trade and assembly applications. The 1/4 inch hex shank seats securely in standard quick-change chucks, reducing slippage during powered fastening. Licensed electricians, plumbers, HVAC technicians, and general contractors who rely on cordless drills and drivers daily will find this a dependable shop and field bit.

This bit is suited for residential and light commercial applications where Phillips head fasteners are common - panel box covers, junction boxes, equipment access panels, fixture mounting, and general mechanical assembly. The PH1 point size targets smaller fastener heads typical in electrical and control enclosure work. The 4-piece pack quantity supports tool crib stocking and service van inventory without overcommitting to bulk quantities.

Key Features

• PH1 Phillips specialty point for precise engagement on Number 1 Phillips fasteners
• 1/4 inch hex drive shank fits standard quick-change bit holders and cordless drill chucks
• 2 inch overall length provides reach in confined fastening locations
• 4.50 mm body diameter for balanced torque transfer without tip flex
• 4-piece pack supports van stock and tool crib replenishment

Compatibility

Designed for use with any power tool or bit holder accepting a standard 1/4 inch hex drive shank. Fits cordless drills, impact drivers, and right-angle attachments equipped with a 1/4 inch quick-change chuck.

Installation Notes

Install this bit into a 1/4 inch quick-change chuck or bit holder before applying power. Confirm the bit is fully seated before driving to prevent cam-out and fastener damage. Inspect bit tips regularly for wear - a worn Phillips tip accelerates fastener head damage and should be replaced promptly. No special tools or certifications are required to change power screwdriver bits, but powered fastening near energized components must follow applicable NEC lockout/tagout procedures.