Wera 05134371001 PH2 Phillips Power Screwdriver Bit 1/4 in Hex

Product Description

The WERA 05134371001 is a PH2 Phillips power screwdriver bit designed for use with 1/4 inch hex drive power tools and impact drivers. Built to handle the demands of production and service work, this bit features a PH2 specialty point size that seats firmly in Phillips fastener heads to reduce cam-out under load. The overall length of 2-3/4 inches provides clearance in recessed or hard-to-reach fastening locations. The 6.00 mm body diameter delivers torsional strength during high-cycle power driving. Weighing just 0.1 pounds, the bit adds negligible mass to any tool setup.

This bit is suited for residential and commercial trade applications where Phillips fasteners are driven repeatedly with electric screwdrivers, cordless drills, or impact drivers. Typical installation scenarios include panel assembly, equipment mounting, cabinet work, and general mechanical fastening. The 1/4 inch hex shank provides universal compatibility with quick-change bit holders and power tool chucks commonly found on jobsites. This pack contains 4 pieces, making it practical to stage spares at the point of work or across multiple tools.

Key Features

• PH2 Phillips specialty point size for positive engagement with No. 2 Phillips fasteners
• 1/4 inch hex drive shank fits standard quick-change bit holders and power tool chucks
• 2-3/4 inch overall length for access in recessed fastening positions
• 6.00 mm body diameter for torsional rigidity under power driving loads
• 4-piece count per package supports staging spares across tools or work areas

Compatibility

Designed as a direct-fit replacement for standard PH2 Phillips power screwdriver bits with a 1/4 inch hex drive shank, compatible with any power tool or bit holder accepting the 1/4 inch hex drive format.

Installation Notes

Installation is performed by any trade professional or knowledgeable technician using a 1/4 inch hex drive power screwdriver, cordless drill, or impact driver. Confirm the bit is fully seated in the tool chuck or quick-change holder before driving. Inspect the bit tip for wear before each use, as a worn PH2 tip increases the risk of cam-out and fastener head damage. Replace bits showing visible rounding or chipping of the tip geometry.