Wera 05118135001 Precision Nut Driver 3/16 Inch Solid Shaft

Product Description

The WERA 05118135001 is a precision nut driver built for exacting fastener work in tight or sensitive assemblies. Sized at 3/16 inch drive with a solid shaft, it delivers direct torque transfer without flex. The overall length is 6-1/4 inches, with a 2-3/8 inch blade length and a 60 mm shaft. The ergonomic handle is shaped to reduce hand fatigue during extended use. This tool suits HVAC technicians, electricians, and other trade professionals who need accurate, controlled driving of small hex nuts in control panels, terminal blocks, and equipment enclosures.

This nut driver is suited for precision work in residential and light commercial applications where small fasteners require consistent torque and control. Typical uses include securing wire terminals, mounting screws on control boards, and fastening panel hardware inside HVAC units, electrical enclosures, and similar equipment. The 3/16 inch drive size is a common fit for small hex nuts found throughout low-voltage control wiring and signal device installations. It is designed for hand use by licensed tradespeople working in confined spaces where a standard-size driver would be impractical.

Key Features

• 3/16 inch drive size fits small hex nuts common in control panels and terminal assemblies
• Solid shaft construction for direct, no-flex torque transfer
• 6-1/4 inch overall length provides reach into recessed fastener locations
• 2-3/8 inch blade length with 60 mm shaft for precise depth control
• Ergonomic handle designed to minimize hand fatigue during repeated use
• Limited lifetime warranty from WERA

Compatibility

Designed as a precision hand tool for 3/16 inch hex nuts commonly found in HVAC controls, electrical panels, and light commercial equipment enclosures.

Installation Notes

This tool is intended for hand use only and should not be adapted to power drivers or torque multipliers. Before servicing any electrical panel or control board, de-energize the circuit and verify with a meter per NEC guidelines. Use appropriate PPE when working inside energized enclosures. Store the driver with the tip protected to preserve edge integrity.