Wera 05060235001 Magnetic Nutsetter 10 Mm Hex 2.5 in

Product Description

The WERA 05060235001 is a 10 mm magnetic nutsetter designed for use with power screwdrivers and impact drivers in professional trade applications. The bit features a 0.25 inch (1/4 inch) drive shank and measures 2.5 inches in overall length, making it well suited for driving hex-head fasteners in tight or standard clearance conditions. The magnetic tip retains fasteners during placement, reducing dropped hardware on the job. This set includes 4 pieces, providing backup bits for extended service without interruption. HVAC technicians, electricians, plumbers, and general contractors will find this nutsetter applicable across a wide range of equipment assembly and service tasks.

The 05060235001 nutsetter is intended for use with 10 mm hex-head fasteners commonly encountered in HVAC equipment panels, electrical enclosures, plumbing fixture mounting, and light structural assembly. It is compatible with standard 1/4 inch hex quick-change bit holders and power tools accepting that drive size. The 2.5 inch overall length provides enough reach for recessed fastener locations without sacrificing control on surface-mounted hardware. The 4-piece pack quantity supports kit builds, truck stock, and replacement of worn bits in existing tool setups.

Key Features

• 10 mm hex drive size for matching hex-head fasteners and nuts
• Magnetic tip retains fasteners during single-hand placement
• 1/4 inch hex shank fits standard quick-change power tool holders
• 2.5 inch overall length suits both standard and moderately recessed fastener locations
• 4-piece pack quantity supports redundancy and tool kit stocking

Compatibility

Designed for use with power screwdrivers, drills, and impact drivers equipped with a standard 1/4 inch hex quick-change bit holder accepting power screwdriver bits of 2.5 inch overall length.

Installation Notes

Install and remove this bit only while the power tool is de-energized or the battery is disconnected. Confirm the drive shank is fully seated in the bit holder before operation. This type of nutsetter is installed by any trade professional using power tools for fastener driving. Inspect the magnetic tip and hex socket for wear or damage before each use, and replace worn bits promptly to avoid fastener damage.