Weller PTO8 Long Conical Soldering Tip Pt Series

Product Description

The WELLER PTO8 is a long conical soldering tip designed for precision soldering work in the PT series tip lineup. Built from copper, this tip delivers efficient heat transfer to the work surface, making it well suited for detail-oriented solder joints in electronics assembly, repair, and light electrical work. At 1 inch in tip length, the long conical geometry allows access to tight spaces and small pad targets where standard tips cannot reach cleanly. Licensed electricians, electronics technicians, and bench repair professionals are the primary users of this tip.

The PTO8 is intended for use with compatible PT series soldering stations. The long conical profile is a common choice for through-hole component work, fine surface-mount rework, and any application where tip-to-pad contact area needs to be minimal and controlled. The tip weighs 0.03 pounds, making the overall iron balance negligible with this tip installed.

Key Features

• Long conical tip geometry for access to tight solder points and small pads
• Copper tip material for efficient thermal conductivity
• 1 inch tip length provides extended reach over standard conical tips
• Part of the PT series tip family for organized tip management across compatible stations
• Lightweight at 0.03 pounds — minimal effect on iron balance

Compatibility

Designed for use with PT series soldering stations. Verify station model compatibility against the PT series tip fitment chart before ordering.

Installation Notes

Tip replacement on soldering stations should be performed with the iron powered off and fully cooled to prevent burns and tip damage during removal. Use the appropriate tip removal tool or wrench if specified by the station manufacturer — do not use pliers directly on the tip body. After installing the PTO8, allow the station to reach operating temperature before tinning the new tip with fresh solder to protect the copper surface and establish proper heat transfer.