Weller ETD Soldering Iron Chisel Tip Et Series

Product Description

The WELLER ETD is a chisel-style soldering iron tip designed for use with compatible Weller soldering stations in the ET series. It features a point width of 0.181 inches and a tip length of 1.358 inches, making it well suited for precise soldering work on through-hole components, wire terminations, and general electronics assembly. The chisel profile allows efficient heat transfer to pad and lead joints. This tip is a standard replacement or spare for technicians who regularly service electronics, perform field wiring terminations, or carry out bench-level soldering tasks in HVAC controls, electrical panels, or instrumentation work.

The ETD tip is intended for bench and field soldering applications where a chisel profile is preferred over a conical or bevel tip. Its compact length and defined point width make it practical for working in tighter PCB layouts and connector assemblies. Technicians performing control board repairs, low-voltage wiring connections, or sensor lead work will find this tip a functional match for steady, repeatable joints. It is sold individually, allowing for targeted replacement without purchasing a full tip set.

Key Features

• Chisel tip profile for efficient heat transfer to pads and leads
• Point width of 0.181 inches for controlled contact area
• Tip length of 1.358 inches (34.50 mm) for reach into standard connector footprints
• Part of the ET series, compatible with Weller ET-series soldering stations
• Sold as a single unit for direct replacement use

Compatibility

Designed for use with Weller ET series soldering stations, as indicated by the ET series designation in the product specifications.

Installation Notes

Tip replacement should be performed by a qualified electronics technician with the soldering station powered off and the tip assembly cooled to ambient temperature before handling. Use the appropriate tip removal tool or wrench recommended for the station model to avoid damaging the heating element or tip retainer. Do not force or overtighten the tip during installation. Consult the station manufacturer documentation for proper tip seating and temperature calibration after replacement.