Weld-on 107730331 Abs Pipe Cement 1 Pint Low Voc

Product Description

The WELD-ON 107730331 is a medium-body, low-VOC solvent cement formulated for joining ABS pipe and fittings in plumbing systems. Manufactured by IPS Corporation under the Weld-On 773 line, this black, liquid-form cement delivers fast setup times and high-strength bonds suited for professional plumbing work. The medium body provides consistent coverage on standard ABS pipe walls without excessive run-off. The low-VOC formula reduces solvent emissions during application, an important factor when working in enclosed spaces with limited ventilation. This product comes in a 1-pint container with an applicator cap for direct use without additional tools.

This cement is intended for plumbing applications where ABS pipe and fittings must be permanently joined. Typical use cases include residential and light commercial drain, waste, and vent (DWV) systems where ABS is the specified pipe material. The fast-setting characteristic is useful in cold-weather conditions or when the job requires minimal cure time before system pressure or flow is restored. Licensed plumbers and experienced pipefitters are the primary installers of this product.

Key Features

• Medium-body formulation provides consistent coverage on standard ABS pipe and fitting surfaces
• Low-VOC chemistry reduces solvent emissions compared to standard-VOC ABS cements
• Fast-setting formula shortens wait time between joint assembly and system use
• Black color matches ABS pipe and fittings for a clean finished appearance
• Integrated applicator cap allows direct application without a separate dauber or brush
• 1-pint container size is practical for single-job or service-call quantities

Compatibility

Designed for use with ABS pipe and fittings in plumbing applications. Consult local plumbing codes and the manufacturer product data sheet to confirm suitability for the specific pipe schedule, diameter, and service conditions on the job.

Installation Notes

Installation of ABS solvent cement joints is typically performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Before applying cement, ensure pipe ends are cut square, deburred, and cleaned of dirt, moisture, and oil. Work in a well-ventilated area and keep the container sealed when not in use to prevent solvent evaporation. Allow adequate cure time before pressurizing or flowing water through the joined assembly.