Value Collection ZSNYDL2-3.7 Fork Terminal 6 Stud

Product Description

The VALUE COLLECTION ZSNYDL2-3.7 is a partially insulated, nylon-sleeved standard fork terminal designed for crimp installation onto 6 stud fasteners. Built with a copper contact and rated at 600 volts, it accepts wire sizes from 1.5 to 2.5 square millimeters. The blue color coding follows standard wiring conventions for quick visual identification during termination work. At 0.9760 inches overall length and 0.2360 inches fork width, this terminal suits tight panel layouts. Licensed electricians and panel wiring technicians install these during control panel builds, field wiring, and industrial termination work where a secure, low-profile spade connection is required.

This fork terminal is suited for residential and commercial electrical panels, motor control centers, instrumentation wiring, and low-voltage control circuits where 600-volt rated crimp terminals are specified. Its partially insulated nylon barrel covers the wire barrel while leaving the fork exposed for direct stud contact. The blue color designation is commonly used to identify the 1.5 to 2.5 square millimeter wire range in European and IEC-style wiring systems, making this terminal a practical fit for both OEM panel assembly and field service applications.

Key Features

• 600-volt rating suitable for control panel and power distribution wiring
• Accepts wire sizes from 1.5 to 2.5 square millimeters
• Copper contact material for reliable conductivity and crimp retention
• Nylon partial insulation with blue color coding for wire gauge identification
• No. 6 stud size with 3.70 millimeter stud diameter for standard terminal block and screw connections
• Crimp termination method for a fast, consistent, tool-based installation

Compatibility

Designed as an OEM-style replacement or standard-stock fork terminal for use on No. 6 stud connections in 600-volt-rated electrical assemblies accepting 1.5 to 2.5 square millimeter wire.

Installation Notes

Installation should be performed by a licensed electrician in accordance with applicable NEC requirements and any relevant local codes. De-energize and lock out all circuits before terminating or replacing wiring. Use a calibrated ratcheting crimp tool appropriate for the wire gauge and terminal barrel size to ensure a gas-tight crimp. Do not solder over a crimped connection, and do not exceed the rated wire size range or voltage rating of the terminal.