Value Collection ZMSCVB75011 Viton O-ring Dash 011 100-pack

Product Description

The VALUE COLLECTION ZMSCVB75011 is a Dash 011 Viton (fluoroelastomer) O-ring sold in a pack of 100. It measures 0.313 inches inside diameter, 0.437 inches outside diameter, and 0.0625 inches (1/16 inch) thick with a round cross section. The fluoroelastomer compound delivers a Shore A hardness of 75, a working temperature range of -15 to 400 degrees F, low compression set, and low gas permeability. These properties make it well-suited for sealing applications where exposure to high heat, petroleum products, or a wide range of chemicals is a concern. Technicians in HVAC, plumbing, and industrial service use these rings anywhere a durable, heat-resistant elastomeric seal is required.

This O-ring is appropriate for both residential and light commercial sealing applications. The Dash 011 sizing is common in valve stems, fittings, and fluid-handling components. The fluoroelastomer material is rated compatible with petroleum products and offers good performance in vacuum service. The 100-piece pack suits service shops and field technicians who need to maintain on-hand inventory of standard seal sizes. Not FDA approved; this ring is not intended for food-contact or pharmaceutical applications.

Key Features

• Fluoroelastomer (Viton-type) compound for broad chemical compatibility
• Rated -15 to 400 degrees F continuous service temperature
• Shore A hardness of 75 for a firm, low-compression-set seal
• Low gas permeability — suitable for vacuum service
• Good resistance to petroleum products and high-heat environments
• Pack of 100 individual O-rings for shop or field stock

Compatibility

Designed as a standard Dash 011 O-ring replacement for valves, fittings, and fluid-handling components that require a fluoroelastomer seal compatible with petroleum products and elevated temperatures.

Installation Notes

Installation should be performed by a qualified technician familiar with the system being serviced. Always shut off fluid supply and relieve system pressure before replacing any seal. Lubricate the O-ring with a compatible fluid or grease before seating to prevent tearing during installation. Inspect the groove for nicks or corrosion that could compromise the seal before inserting the new ring.