Value Collection ZMSCV70932 Viton O-ring Dash 932 12-pack

Product Description

The VALUE COLLECTION ZMSCV70932 is a Dash 932 Viton fluoroelastomer O-ring used to create a reliable static seal in fluid and gas systems across HVAC, plumbing, hydraulic, and industrial applications. With a 2.337-inch inside diameter, a 2.573-inch outside diameter, and a 0.118-inch cross-section thickness, this round-profile ring seals straight-thread tube fittings as an O-ring boss gasket. Rated at 70 Shore A hardness, it handles operating temperatures from -15 degrees F to 400 degrees F and maintains a low compression set over service life. Sold in a package of 12.

This O-ring is suited for systems handling petroleum-based fluids, hydraulic oils, and a broad range of chemical media where fluoroelastomer resistance is required. Its low gas permeability makes it appropriate for vacuum service lines as well as pressurized fluid circuits. Plumbers, HVAC technicians, and industrial maintenance technicians typically specify Viton O-rings in applications where standard nitrile or EPDM rings would degrade due to high temperatures or chemical exposure. The Dash 932 size is a standard designation, making cross-referencing and replacement straightforward on the job site.

Key Features

• Fluoroelastomer (Viton) material provides high temperature resistance up to 400 degrees F
• Low compression set maintains sealing force over extended service life
• Low gas permeability suitable for vacuum service applications
• Good resistance to petroleum products and a wide spectrum of chemical media
• Round cross-section profile fits standard O-ring boss grooves for straight-thread tube fittings
• Sold in a 12-piece package to support service inventory stocking

Compatibility

Designed as a standard Dash 932 O-ring boss gasket for use with straight-thread tube fittings in petroleum-compatible fluid and gas systems. Compatible with petroleum products and related hydraulic and fuel media.

Installation Notes

Installation is performed by plumbers, HVAC technicians, or hydraulic system technicians during fitting assembly or repair. Shut down and depressurize the system fully before removing any fittings or replacing seals. Lightly lubricate the O-ring with a compatible fluid or assembly lubricant before seating it in the groove to prevent twisting or pinching during installation. Do not reuse a compressed or damaged O-ring.