Value Collection ZMSCV70113 Viton O-ring Dash 113 100-pack

Product Description

The VALUE COLLECTION ZMSCV70113 is a Dash 113 Viton O-ring designed for static and dynamic sealing applications in systems that handle petroleum products, fuels, hydraulic fluids, and high-temperature media. Manufactured from fluoroelastomer with a Shore A hardness of 70, this O-ring delivers a low compression set and strong resistance to elevated temperatures up to 400 degrees F and down to -15 degrees F. The round cross section measures 0.0937 inches thick, with an inside diameter of 0.563 inches and an outside diameter of 0.750 inches. It is suited for HVAC, plumbing, hydraulic, and industrial service applications. Sold in a package of 100 pieces.

This O-ring is used in a wide range of trade and industrial applications where fluoroelastomer sealing material is specified. Common install scenarios include fuel systems, refrigerant service ports, hydraulic fittings, and vacuum service assemblies where petroleum product compatibility and low gas permeability are required. The Dash 113 designation is a standard AS568 size, making it a straightforward replacement in any application calling for that dash number in Viton or fluoroelastomer material. HVAC technicians, plumbers, and hydraulic system technicians regularly stock this size for field repairs and preventive maintenance.

Key Features

• Fluoroelastomer (Viton) construction with good resistance to petroleum products and fuels
• Operating temperature range of -15 degrees F to 400 degrees F
• Low compression set and high temperature resistance for long-term sealing performance
• Good for vacuum service with low gas permeability
• Wide spectrum of chemical compatibility
• Round cross section, Dash 113 standard AS568 sizing

Compatibility

Designed as a standard Dash 113 fluoroelastomer O-ring replacement compatible with petroleum products and a wide spectrum of chemical media. Suitable for any application specifying a Dash 113 Viton O-ring with a 0.563-inch inside diameter and 0.750-inch outside diameter.

Installation Notes

Installation should be performed by a qualified technician following the appropriate trade code or equipment service manual for the system being serviced. Always depressurize, de-energize, or shut off flow to the assembly before replacing any O-ring seal. Avoid using sharp tools that could nick or cut the O-ring during installation, and apply a compatible lubricant as specified for the service media. Inspect the seating surface for damage before installing the new O-ring.