Value Collection ZMSCV70011 Viton O-ring Dash 011 100 Pack

Product Description

The VALUE COLLECTION ZMSCV70011 is a Dash 011 Viton O-ring used for static and dynamic sealing applications in fluid and gas systems. Manufactured from fluoroelastomer, this O-ring measures 0.313 inches inside diameter, 0.438 inches outside diameter, and 0.0625 inches thick with a round cross section. The durometer hardness rating is 70, placing it in the hard range, which supports low compression set and reliable sealing under sustained load. The material provides high temperature resistance up to 400 degrees F and a low minimum working temperature of -15 degrees F. Licensed HVAC technicians, plumbers, and mechanical contractors typically specify Viton O-rings where petroleum-based fluids, high heat, or chemical exposure would degrade standard nitrile compounds.

This O-ring is suited for use in HVAC refrigerant circuits, hydraulic systems, fuel handling lines, vacuum service equipment, and industrial fluid connections where broad chemical compatibility is required. The fluoroelastomer compound resists petroleum products and exhibits low gas permeability, making it appropriate for both liquid and gas sealing duties. It is sold in a package quantity of 100, supporting stocking for service fleets or shop inventory. The minimum order quantity is 1 package.

Key Features

• Fluoroelastomer (Viton) material with broad chemical compatibility including petroleum products
• Operating temperature range: -15 degrees F to 400 degrees F
• Durometer hardness of 70 (hard) for low compression set under sustained clamping load
• Round cross section, Dash 011 standard sizing
• Suitable for vacuum service with low gas permeability
• Package quantity of 100 for shop or fleet stocking

Compatibility

Designed as a standard Dash 011 O-ring replacement compatible with grooves and fittings dimensioned to 0.313 inches ID and 0.438 inches OD per standard O-ring dash sizing. Compatible with systems handling petroleum products and fluids where fluoroelastomer resistance is required.

Installation Notes

Installation is performed by licensed plumbers, HVAC technicians, hydraulic system technicians, or qualified mechanical contractors. Always depressurize and isolate the system before removing the old O-ring and inspect the groove for scoring or contamination before seating the new O-ring. Apply a compatible lubricant to the O-ring before installation to prevent tearing during assembly. Do not overstretch the O-ring during placement, as this can reduce effective sealing cross section.