Value Collection ZMSCV2.5X13 Viton O-ring 13mm Id 18mm Od

Product Description

The VALUE COLLECTION ZMSCV2.5X13 is a round cross-section Viton O-ring manufactured from fluoroelastomer compound. It measures 13mm inside diameter, 18mm outside diameter, and 2.5mm in thickness. The black elastomer body carries a hardness rating of 75 Shore A, placing it in the hard durometer range. Rated for continuous service from -15 degrees F to 400 degrees F, this O-ring is well suited for sealing applications where elevated temperature resistance and low compression set are required. Licensed plumbers, pipefitters, and maintenance technicians commonly specify fluoroelastomer O-rings for demanding fluid and vacuum service environments.

This O-ring is suited for sealing petroleum-based media, hydraulic fluids, and chemical service lines in both residential and commercial mechanical systems. Its low gas permeability makes it a practical choice for vacuum service applications. The wide chemical compatibility of the fluoroelastomer compound supports use in equipment exposed to a broad spectrum of industrial fluids. Installers working with pump housings, valve bodies, fluid fittings, and mechanical face seals will find this profile a common replacement geometry.

Key Features

• Fluoroelastomer (Viton) compound provides high temperature resistance up to 400 degrees F
• Low compression set maintains seal integrity under sustained load
• Good resistance to petroleum products and a wide spectrum of chemical media
• Low gas permeability supports vacuum service applications
• Round cross-section profile fits standard O-ring groove dimensions
• 75 Shore A hardness rating for hard-durometer sealing requirements

Compatibility

Designed as a replacement O-ring for applications requiring a 13mm ID, 18mm OD, 2.5mm thick round cross-section fluoroelastomer seal compatible with petroleum products and high-temperature fluid service.

Installation Notes

Installation of O-rings should be performed by a qualified technician following equipment manufacturer guidelines. Depressurize and isolate the system before disassembly, and verify the groove dimensions match the O-ring cross-section to prevent extrusion or compression failure. Lubricate the O-ring with a compatible fluid or grease before seating to avoid nicking the elastomer during installation. Inspect the seating groove for burrs, corrosion, or damage before fitting the replacement seal.