Value Collection ZMSCH2X6 O-ring 6in Id 10in Od Nbr

Product Description

The VALUE COLLECTION ZMSCH2X6 is a round-cross-section O-ring made from Nitrile Butadiene Rubber (Buna-N), the most widely used elastomer in fluid sealing applications. With a 6-inch inside diameter, 10-inch outside diameter, and 2-inch cross-section thickness, this O-ring is sized for large-bore static or dynamic sealing tasks. It carries a Shore A hardness of 70, placing it in the hard range for improved resistance to compression set, tear, and abrasion. It performs across a working temperature range of -40 degrees F to 250 degrees F, making it suitable for a broad range of industrial and mechanical service conditions. Licensed plumbers, pipefitters, and maintenance mechanics are the primary installers.

This O-ring is engineered for sealing applications involving petroleum-based fluids, hydraulic oils, fuels, and water. Its Buna-N compound delivers excellent resistance to petroleum products, making it a go-to choice in hydraulic systems, pump housings, valve bodies, compressors, and fluid transfer assemblies. The large 6-inch ID suits heavy industrial, commercial HVAC, and process-piping applications where standard small-bore O-rings are not appropriate. It meets SAE and MIL-Spec standards. Note: This O-ring is not FDA approved and should not be used in food-contact or potable-water service without verification of applicable regulatory requirements.

Key Features

• Buna-N (Nitrile Butadiene Rubber) construction provides excellent petroleum-fluid resistance
• Shore A hardness of 70 for strong compression set and abrasion resistance
• Operating range of -40 degrees F to 250 degrees F suits wide thermal swings
• Round cross-section profile for consistent sealing load distribution
• Meets SAE and MIL-Spec standards for material and dimensional conformance
• Sold in packages of 100 units; minimum order quantity of 1 package

Compatibility

Designed for use with petroleum products, hydraulic oils, fuels, and similar mineral-oil-based media. Not recommended for use with ozone, strong acids, ketones, esters, or chlorinated solvents. Do not store near direct sunlight, electric motors, or other ozone-generating equipment.

Installation Notes

Installation is typically performed by licensed plumbers, pipefitters, or qualified maintenance mechanics. Always depressurize and isolate the system before removing or installing O-rings. Lubricate the O-ring with a compatible fluid or assembly lubricant to prevent pinching or tearing during installation. Inspect the groove dimensions for proper fit before seating the ring; oversized or undersized grooves will compromise the seal.