Value Collection XM01B2144 Worm Gear Clamp Sae 20

Product Description

The VALUE COLLECTION XM01B2144 is a worm drive gear clamp rated SAE Size 20, designed to secure hoses, tubing, and flexible connections across a range of trade applications. The clamp accommodates a clamping diameter range of 0.827 inches minimum to 1.75 inches maximum, making it well-suited for standard hose assemblies encountered in plumbing, HVAC, and general mechanical work. The band is constructed from 301 grade stainless steel and carbon steel, offering corrosion resistance alongside structural strength. At 5/16 inch wide, the band delivers consistent sealing pressure across the clamped surface. At 0.03 pounds, the clamp is lightweight and easy to handle during installation.

This worm gear clamp is used in residential and light commercial applications where a reliable, adjustable hose clamp is needed. Typical installation scenarios include securing coolant hoses, drain lines, flexible conduit connections, and HVAC condensate or bypass lines. The SAE 20 designation standardizes the size for straightforward identification and cross-referencing on the job. It is appropriate for use by plumbers, HVAC technicians, and general mechanical trades requiring a reusable, screw-adjusted clamp solution.

Key Features

• SAE Size 20 designation for standardized identification and sizing
• Adjustable clamping range from 0.827 inches to 1.75 inches diameter
• 301 grade stainless steel and carbon steel band construction for corrosion resistance and durability
• 5/16 inch band width provides even clamping pressure distribution
• Worm drive mechanism allows precise tightening and adjustment with a standard screwdriver or nut driver
• Lightweight at 0.03 pounds for easy single-hand positioning during installation

Compatibility

Designed as a standard SAE 20 worm gear clamp suitable for hoses and flexible tubing with an outside diameter between 0.827 inches and 1.75 inches across plumbing, HVAC, and general mechanical applications.

Installation Notes

Installation is typically performed by plumbers, HVAC technicians, or general mechanical trades using a flat-head screwdriver or 5/16 inch hex nut driver. Ensure the hose or tubing is fully seated on the fitting before positioning the clamp, and place the clamp band entirely over the hose end for a secure seal. Power down or depressurize any connected system before removing or replacing an existing clamp. Do not overtighten, as excessive torque can damage the hose or tubing material.