Value Collection WS-PL-0987010PP Cartridge Filter 10 Micron

Product Description

The VALUE COLLECTION WS-PL-0987010PP is a string-wound polypropylene cartridge filter designed to reduce sediment from potable water and process fluid systems. Measuring 2.5 inches in outside diameter and 9.875 inches in length, it fits standard 10-inch filter housings used in residential and light commercial plumbing applications. The 10-micron rating captures fine sediment particles including sand, silt, rust, and scale. Both the core and media are constructed from polypropylene, making this filter compatible with a broad range of water chemistries. It is installed by licensed plumbers and qualified water treatment technicians.

This filter is suited for use in whole-house sediment filtration systems, under-sink pre-filtration setups, and light commercial water treatment applications. The string-wound construction provides depth filtration, trapping particles throughout the media rather than only at the surface. It is rated for flow rates up to 10 gallons per minute (GPM) and can handle water temperatures up to 140 degrees F, making it appropriate for cold and warm water supply lines in residential and small commercial installations.

Key Features

• 10-micron rating targets sediment including sand, silt, rust, and scale
• String-wound polypropylene media provides depth filtration for extended service life
• Polypropylene core and media construction resists corrosion and a wide range of water chemistries
• Maximum flow rate of 10 GPM supports whole-house and light commercial applications
• Rated to 140 degrees F for use on warm water supply lines
• Standard 10-inch sizing fits widely available filter housings

Compatibility

Designed as an OEM-style replacement or standard-fit cartridge for residential and light commercial plumbing filter housings that accept 2.5-inch OD, 10-inch length string-wound cartridges.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and IPC guidelines. Shut off the water supply and relieve line pressure before opening the filter housing. Inspect the housing O-ring and replace it if worn before seating the new cartridge. Do not overtighten the filter housing sump; hand-tight plus a quarter turn with a housing wrench is the accepted practice for most standard housings.