Value Collection WS-MH-FIBR-040 Polypropylene Rope 100 Ft

Product Description

The VALUE COLLECTION WS-MH-FIBR-040 is a solid braid polypropylene rope rated for 100 feet of length and a 1/4 inch diameter. It is constructed for abrasion resistance, making it suitable for repeated contact with surfaces, edges, and equipment without rapid degradation. With a load capacity of 127 pounds, this rope is used in general-purpose utility applications across trades and industrial settings. The polypropylene construction resists moisture and most chemicals, keeping it functional in wet or outdoor environments. Tradespeople, maintenance crews, and service technicians keep this type of rope on hand for pull lines, bundling, and securing loads during installation work.

This rope is a general utility product used across a range of trade and light industrial applications. Common uses include routing low-voltage wire through conduit, bundling pipe or duct sections during staging, and securing materials during transport or rigging work. The 100 foot length provides enough run for most single-floor or rooftop applications. Its compact 1/4 inch diameter allows it to thread through tight spaces while still providing meaningful tensile support up to its rated capacity.

Key Features

• Solid braid construction provides consistent diameter and smooth surface for reduced friction when pulling through conduit or over surfaces
• Abrasion-resistant design extends service life in contact with rough edges, concrete, and equipment surfaces
• Polypropylene material resists moisture, making it suitable for outdoor, rooftop, and wet-environment use
• 127 pound load capacity supports light utility rigging, bundling, and pull-line applications
• 1/4 inch diameter fits through standard conduit knockout openings and tight routing paths
• 100 foot length covers typical single-floor or rooftop service runs without splicing

Compatibility

Designed as a general-purpose utility rope suitable for HVAC, plumbing, electrical, and general trade applications where a lightweight, abrasion-resistant pull or tie line is required.

Installation Notes

No special tools are required to cut or deploy this rope; a utility knife or rope shears will produce a clean cut. When used as a pull line for low-voltage or electrical wire, ensure all power is de-energized before pulling through live conduit runs. Avoid exceeding the 127 pound rated capacity during any load-bearing or rigging use. Inspect the rope for fraying or wear before each use and retire it from service if damage is observed.