Value Collection WPFI0-803000-100BX No.8 3in Flat Head Wood Screw

Product Description

The VALUE COLLECTION WPFI0-803000-100BX is a No. 8 flat head wood screw with a Phillips drive, sold in a box of 100. At 3 inches overall length, this screw is built for general wood fastening applications where a flush or countersunk finish is required. Constructed from Grade 2 steel with a zinc plating, it provides basic corrosion resistance suitable for interior applications. The flat head geometry allows the fastener to sit flush with or slightly below the surface of the workpiece when driven into a properly countersunk pilot hole. Carpenters, finish contractors, and general tradespeople commonly use this screw size for decking, framing trim, cabinet installation, and structural wood assembly.

This screw is appropriate for residential and light commercial construction tasks involving wood-to-wood fastening. The No. 8 thread diameter paired with a 3-inch length makes it a common choice for attaching dimensional lumber, securing subfloor panels, and general carpentry work. The zinc plated finish offers adequate protection in dry, indoor environments. The box quantity of 100 units suits job-site use where consistent fastener availability is needed across a project.

Key Features

• No. 8 thread size for medium-duty wood fastening
• 3-inch overall length for deeper bite into dimensional lumber
• Flat head profile allows flush or countersunk seating
• Phillips drive compatible with standard power and hand drivers
• Grade 2 steel construction with zinc plated finish for basic corrosion resistance
• Box of 100 units for consistent job-site supply

Compatibility

Designed as a general-purpose flat head wood screw suitable for use in standard wood fastening applications where a No. 8 diameter, 3-inch Phillips drive fastener is specified.

Installation Notes

Carpenters and general contractors install this fastener using a Phillips-head driver bit, either by hand or with a power drill or impact driver set to appropriate torque. Pre-drilling a pilot hole sized for the shank diameter is recommended to prevent wood splitting, particularly near board edges or ends. The flat head requires a countersink to seat flush with the surface. This screw is intended for interior or dry-environment use given its zinc plated finish; consult applicable building codes for fastener requirements in structural or exterior applications.