Value Collection WPFI0-600750-100BX Wood Screw No6 3/4in

Product Description

The VALUE COLLECTION WPFI0-600750-100BX is a No. 6 flat head wood screw designed for general fastening applications in wood substrates. The flat head profile sits flush with or below the surface when fully driven, producing a clean finish without a protruding fastener head. Constructed from Grade 2 steel with a zinc plating, these screws resist light corrosion and are well suited for interior woodworking, cabinetry, trim, and light structural assembly. Each screw measures 3/4 inches in overall length and is driven with a standard Phillips bit. This box contains 100 pieces.

These screws are a practical choice for residential and light commercial interior applications. Typical uses include securing wood trim, drawer components, cabinet face frames, and general millwork. The zinc plating provides a protective layer appropriate for dry indoor environments. The No. 6 diameter and 3/4-inch length make this fastener well matched to thin stock and overlay applications where a shorter screw is required to avoid blow-through. Carpenters, finish installers, and general contractors commonly stock this size as a daily-use fastener.

Key Features

• Flat head profile seats flush with the work surface for a clean finished appearance
• Phillips drive compatible with standard No. 2 Phillips bits and most cordless drivers
• Grade 2 steel construction provides reliable tensile strength for light to moderate load applications
• Zinc plating offers corrosion resistance in dry interior environments
• 3/4-inch overall length suits thin stock and overlay fastening without blow-through
• Sold in a box of 100 pieces for consistent jobsite supply

Compatibility

Designed as a general-purpose flat head wood screw for use in softwood and hardwood substrates in interior fastening applications.

Installation Notes

Installation is performed by carpenters and general trade workers using a cordless drill or driver fitted with a No. 2 Phillips bit. Pre-drilling a pilot hole is recommended in hardwoods or near the edge of stock to prevent splitting. Drive screws to flush or just below the surface; do not overdrive into the substrate as this can strip the head or compromise holding strength. Follow applicable building codes for fastener spacing and load requirements.