Value Collection WPFI0-600500-100BX Flat Head Wood Screw

Product Description

The VALUE COLLECTION WPFI0-600500-100BX is a No. 6 flat head wood screw designed for fastening wood materials in general construction, carpentry, and finish applications. The Phillips drive recess allows for fast, controlled installation with standard power or hand tools. Built from Grade 2 steel with a zinc plated finish, this screw resists corrosion in typical indoor environments. At 0.5 inches overall length, it is suited for securing thin stock, trim, and light-duty wood assemblies. Sold in a box of 100, this SKU is sized for job-site use or shop stocking by carpenters, contractors, and millwork installers.

This flat head wood screw is intended for residential and light commercial woodworking applications where a countersunk head profile is required. The flat head seats flush with or below the material surface, making it appropriate for finish carpentry, cabinet assembly, drawer construction, and similar tasks where a clean surface appearance is needed after fastening. The 0.5 inch length is best suited for thin panels, veneered sheet goods, and layered assemblies where a longer fastener would risk breakthrough.

Key Features

• No. 6 thread size for light-duty wood fastening
• Flat head profile countersinks flush for a clean finish surface
• Phillips drive compatible with standard No. 2 Phillips bits
• Grade 2 steel construction for reliable shear and tensile strength in typical wood applications
• Zinc plated finish provides corrosion resistance in dry indoor environments
• Sold in a 100-count box for efficient job-site or shop stocking

Compatibility

Designed as a general-purpose flat head wood screw suitable for softwood and hardwood fastening applications requiring a No. 6 thread size and a countersunk head profile.

Installation Notes

Installation is performed by carpenters, woodworkers, and general contractors using a No. 2 Phillips bit in a hand screwdriver or power driver set to appropriate torque to avoid overdriving. Pre-drilling a pilot hole is recommended in hardwoods or near edges to prevent splitting. Always countersink the surface material to the correct angle to allow the flat head to seat properly. Avoid use in exterior or high-moisture applications where additional corrosion protection beyond zinc plating would be required.