Value Collection WPFI-1401250-100BX Wood Screw 100ct

Product Description

The VALUE COLLECTION WPFI-1401250-100BX is a No. 14 flat head wood screw built to ASME B18.6.1 standards. It features a Phillips drive recess and measures 1-1/4 inches overall length. The screw is manufactured from Grade 2 steel with a zinc plated finish for basic corrosion resistance. This fastener is suited for wood-to-wood and wood-to-substrate assembly work in construction, cabinetry, and general carpentry applications. It is sold in a box quantity of 100 screws. Electricians, carpenters, and general contractors reach for this size when securing electrical boxes, wood framing components, and finish work that calls for a countersunk fastener profile.

This screw is appropriate for residential and light commercial construction tasks where a No. 14 diameter fastener is specified. The flat head design sits flush or countersunk in the workpiece, making it a common choice for trim, decking substrates, and structural wood connections. The zinc plating provides a degree of protection in dry interior environments. The 100-piece box format suits service vans, job-site bins, and shop inventory replenishment.

Key Features

• No. 14 thread size with 1-1/4 inch overall length for medium-depth wood fastening
• Flat head profile countersinks flush for a clean finished surface
• Phillips drive compatible with standard No. 2 Phillips bits and impact drivers
• Grade 2 steel construction meets ASME B18.6.1 dimensional standards
• Zinc plated finish adds basic corrosion resistance for dry interior use
• Sold in a 100-piece box for convenient bulk restocking

Compatibility

Designed as a standard No. 14 flat head Phillips wood screw per ASME B18.6.1, compatible with typical wood substrates and materials requiring a countersunk fastener in residential and light commercial applications.

Installation Notes

Install using a No. 2 Phillips bit in a drill or impact driver set to an appropriate clutch setting to avoid overdriving and stripping the drive recess. Pre-drilling a pilot hole is recommended in hardwoods or near board edges to prevent splitting. Countersink the pilot hole to allow the flat head to seat fully flush with the surface. Always follow applicable building codes and project specifications when selecting fastener size and spacing.