Value Collection WPFI-1000750-050B No.10 Flat Head Screw

Product Description

The VALUE COLLECTION WPFI-1000750-050B is a No. 10 flat head Phillips sheet metal screw designed for fastening into sheet metal, light-gauge steel, and similar thin-material assemblies. At 0.75 inches in length under the head, this screw sits flush when driven, eliminating protrusion in panel and enclosure applications. Constructed from steel with a zinc finish, it resists corrosion in typical indoor service environments. This fastener is sold in a minimum quantity of 50 pieces per order, making it practical for service techs and installers who need job-site quantities rather than bulk industrial lots.

Sheet metal screws of this type are common in HVAC ductwork assembly, electrical enclosure installation, and light fabrication work. The No. 10 thread size is a widely used trade standard for attaching sheet metal panels, junction box covers, equipment access doors, and similar components. The flat head profile is appropriate where a countersunk, flush finish is required. Phillips drive makes installation fast with standard hand or power tools.

Key Features

• No. 10 thread size — standard trade sizing for sheet metal and enclosure work
• 0.75-inch length under head for secure engagement in light-gauge material
• Flat head profile seats flush in countersunk holes
• Phillips drive compatible with standard hand screwdrivers and power bits
• Steel construction with zinc finish for corrosion resistance in indoor applications
• Sold in 50-piece increments for job-site and service use

Compatibility

Designed as a general-purpose No. 10 flat head Phillips sheet metal screw suitable for standard sheet metal fastening applications across HVAC, electrical, and light fabrication trades.

Installation Notes

Sheet metal screws should be installed by qualified tradespeople following applicable codes, including NEC requirements for electrical enclosure fasteners where relevant. Use a properly sized Phillips bit to avoid cam-out and fastener damage. Pilot holes are recommended in heavier-gauge material to prevent sheet distortion. Always de-energize electrical equipment and isolate any associated systems before accessing panels or enclosures secured with these fasteners.