Value Collection TKPPI0-600620-2-100B No. 6 Pan Head Screw

Product Description

The VALUE COLLECTION TKPPI0-600620-2-100B is a No. 6 pan head sheet metal screw with a Phillips drive, sold in a pack of 100. Constructed from steel with a zinc finish, this fastener is designed for securing sheet metal panels, housings, and light-gauge metal assemblies. The pan head profile sits flush to slightly above the work surface, providing a broad bearing surface that resists pull-through. At 5/8 inches in length under the head, this screw is well-suited for thin-gauge metal-to-metal or metal-to-substrate connections common in HVAC equipment, electrical enclosures, and ductwork fabrication.

This fastener is used across a range of trade applications including HVAC ductwork assembly, equipment panel attachment, electrical enclosure work, and light sheet metal fabrication. The No. 6 thread size and 5/8-inch length are standard dimensions for attaching access doors, cabinet panels, and sheet metal covers in both residential and light commercial installations. The zinc finish provides basic corrosion resistance suitable for interior and protected exterior applications.

Key Features

• No. 6 thread size for light-gauge sheet metal fastening
• 5/8 inch length under head fits thin-gauge metal assemblies
• Pan head profile provides wide bearing surface to resist pull-through
• Phillips drive compatible with standard power drivers and hand screwdrivers
• Steel construction with zinc finish for basic corrosion resistance
• Sold in a pack of 100 for job-site and shop use

Compatibility

Designed as a standard No. 6 pan head Phillips sheet metal screw suitable for light-gauge steel panels, HVAC equipment housings, electrical enclosures, and ductwork assemblies requiring a 5/8-inch fastener.

Installation Notes

Sheet metal screws are installed by HVAC technicians, electricians, and sheet metal workers using a Phillips bit in a power driver or manual screwdriver. Pre-drilling a pilot hole in harder or thicker gauge metal reduces the risk of panel distortion. Do not overtighten, as pan head sheet metal screws can strip or deform thin-gauge material if over-driven. Follow applicable codes for fastener spacing and placement in ductwork or enclosure applications.