Value Collection TKPPI-1000750-100BX No.10 Pan Head Screw

Product Description

The VALUE COLLECTION TKPPI-1000750-100BX is a No. 10 pan head, Phillips drive, self-drilling screw designed for fast, reliable fastening in metal-to-metal and light-gauge sheet metal applications. Built from steel with a zinc-plated finish for corrosion resistance, this screw features a No. 2 drill point that eliminates the need for a pilot hole. The 3/4-inch length under head suits thin-gauge work where thread engagement and pull-through resistance matter. Electricians, HVAC technicians, and sheet metal workers rely on this type of fastener for securing ductwork, electrical enclosures, panels, and similar assemblies. This box contains 100 screws.

This screw is suited for light-gauge steel fabrication, HVAC duct assembly, electrical panel and enclosure work, and general sheet metal fastening in both residential and commercial settings. The pan head profile provides a wide bearing surface that resists pull-through on thin materials. The Phillips drive is compatible with standard No. 2 Phillips bits used in cordless drills and screw guns common on any trade job site.

Key Features

• No. 2 drill point eliminates pilot hole drilling in light-gauge sheet metal
• Pan head profile delivers broad bearing surface and low-profile finish
• Phillips drive compatible with standard No. 2 bits and screw guns
• Steel construction with zinc-plated finish for corrosion resistance
• 3/4-inch length under head suits thin-gauge and shallow-depth fastening
• Sold in a 100-count box for job-site convenience

Compatibility

Designed as a general-purpose No. 10 self-drilling pan head screw for use in light-gauge steel sheet metal, HVAC ductwork, electrical enclosures, and similar trade applications where a pilot hole is not practical.

Installation Notes

Installation is typically performed by HVAC sheet metal workers, electricians, or general contractors using a cordless drill or screw gun fitted with a No. 2 Phillips bit. Apply consistent, moderate pressure to allow the drill point to self-start without walking. Do not overdrive — stop when the head seats flush against the material surface to avoid stripping or deforming thin gauge metal. Follow applicable codes such as SMACNA duct construction standards or NEC requirements for enclosure fastening where relevant.