Value Collection SVY5-5-50PK Fork Terminal 10 Stud 50 Pack

Product Description

The VALUE COLLECTION SVY5-5-50PK is a partially insulated standard fork terminal designed for use in electrical wiring applications requiring a secure, low-profile lug connection. This terminal accommodates 12 to 10 AWG wire and is rated at 600 volts, making it suitable for panel wiring, control circuits, and equipment terminations found in HVAC, industrial, and general electrical work. The fork width measures 0.354 inches with an overall length of 1.004 inches and a contact thickness of 0.039 inches. Copper contacts ensure reliable conductivity, and the yellow vinyl insulation provides partial wire strain relief and easy gauge identification at a glance. This pack contains 50 terminals.

These fork terminals are suited for residential and light commercial electrical installations where a semi-permanent, screw-terminal connection is needed. They are commonly used on terminal blocks, control boards, motor connections, and equipment bus bars. The partially insulated design allows the fork tang to make direct metal-to-metal contact with the stud while the barrel protects the wire entry point. Electricians and HVAC technicians install these during new equipment wiring, panel retrofits, and control wiring runs where a #10 stud termination point is present.

Key Features

• Rated at 600 volts for use in standard low-voltage and line-voltage control circuits
• Accepts 12 to 10 AWG wire for versatile gauge compatibility
• Copper contacts provide low-resistance, corrosion-resistant termination
• Yellow vinyl partial insulation aids wire strain relief and AWG identification
• Fork width of 0.354 inches fits standard #10 stud hardware
• Pack of 50 terminals reduces restocking frequency on active job sites

Compatibility

Designed as a standard replacement or stocking fork terminal for #10 stud applications on terminal blocks, control boards, and equipment binding posts wired with 12 to 10 AWG copper conductors.

Installation Notes

Installation should be performed by a licensed electrician or qualified HVAC technician in accordance with applicable NEC requirements. De-energize the circuit completely before terminating or inspecting any wiring connection. Use a calibrated ratchet crimping tool rated for the terminal barrel size to ensure a full, gas-tight crimp. Do not over-torque the mounting stud, as this can deform the fork tang and compromise the connection.