Value Collection SO2392-16 Angle Chisel Hammer Chipper

Product Description

The VALUE COLLECTION SO2392-16 is an angle-type replacement chisel designed for use with hammer chippers and pneumatic chipping hammers. Machined from steel with a round shank measuring 1/2 inch in diameter, it delivers consistent chipping performance on concrete, masonry, metal slag, and weld scale. The angled cutting head spans 1-3/8 inches wide, making it well suited for working in confined areas or along surface edges. Overall length is 7 inches, providing a practical balance between reach and control. Weighing 0.4 pounds, the chisel is light enough for extended use without adding fatigue. Licensed tradespeople and maintenance technicians working in industrial, construction, or facility maintenance settings are the primary users of this tool.

This chisel is used wherever a pneumatic or electric hammer chipper is employed to break up concrete, remove mortar joints, chip weld slag, or scale metal surfaces. The angle geometry makes it particularly effective for corner work, edge trimming, and detail chipping where a flat or narrow point chisel cannot reach cleanly. It suits residential and commercial construction, structural steel fabrication shops, and heavy-maintenance environments.

Key Features

• Angle-style cutting head for corner and edge chipping applications
• 1-3/8 inch head width for broad material removal in tight areas
• 1/2 inch round shank for secure chuck retention in standard hammer chippers
• 7 inch overall length balances reach and handling control
• Steel construction for durability under repeated impact loads
• Lightweight at 0.4 pounds to reduce operator fatigue

Compatibility

Designed as an OEM-style replacement chisel for hammer chippers and pneumatic chipping hammers that accept a 1/2 inch round shank tool bit.

Installation Notes

Installation is performed by tradespeople and maintenance technicians familiar with pneumatic or electric hammer chippers. Before inserting or removing the chisel, disconnect the air supply or unplug the tool and verify all stored energy is released. Insert the shank fully into the tool chuck and confirm the retainer clip or collar is seated before operating. Always wear appropriate personal protective equipment including eye protection and hearing protection when operating chipping equipment.