Value Collection SMSPI0-60037B0-100BX Sheet Metal Screw No 6

Product Description

The VALUE COLLECTION SMSPI0-60037B0-100BX is a No. 6 pan head sheet metal screw designed for fastening thin-gauge metal components in HVAC, electrical, and general trade applications. The Phillips drive and Type B point allow the screw to self-tap into pre-drilled or punched sheet metal without requiring a nut. The 3/8-inch length is measured under the head. Constructed from Grade 2 steel with a zinc finish, this screw resists corrosion in typical indoor mechanical environments. Sold in a box of 100 units.

This fastener is commonly used by HVAC technicians, sheet metal fabricators, electricians, and plumbers for securing duct panels, junction box covers, access panels, equipment housings, and similar thin-metal assemblies. The pan head profile provides a wide bearing surface and a low-profile sit that works well in confined spaces where a truss or hex head may interfere with adjacent components. The Type B point, which features a tapered tip with coarse threads, is suitable for light-gauge steel sheet applications.

Key Features

• No. 6 thread size for light-gauge sheet metal fastening
• 3/8-inch length under head suits shallow material thickness applications
• Pan head with Phillips drive for standard screwdriver or bit access
• Type B point self-taps into pre-punched or pre-drilled sheet metal
• Grade 2 steel construction with zinc finish for corrosion resistance
• Box of 100 screws for job-site and shop use

Compatibility

Designed as a standard No. 6 Type B pan head sheet metal screw for use in light-gauge steel sheet metal assemblies typical in HVAC ductwork, electrical enclosures, and general trade fabrication work.

Installation Notes

Installation requires a Phillips bit driver or screwdriver; a power drill with adjustable clutch is recommended to avoid stripping the drive or over-driving into thin gauge material. Pre-drill or punch a pilot hole sized for the No. 6 thread before driving to reduce material distortion. Power down any electrical equipment before fastening covers or panels. Follow applicable NEC or IFGC guidelines when securing enclosures on energized systems.