Value Collection SMSPI0-200500-100BX No. 2 Pan Head Screw

Product Description

The VALUE COLLECTION SMSPI0-200500-100BX is a No. 2 pan head sheet metal screw with a slotted drive, supplied in a box of 100. It features a Type AB point, which combines the thread-cutting action of Type A with a finer starting taper, making it well-suited for fastening thin sheet metal, light-gauge steel, and similar materials. The screw is made from Grade 2 steel with a zinc finish that provides basic corrosion resistance in typical indoor environments. Length under head measures 0.5 inches. These fasteners are a standard consumable for mechanical, HVAC, and general trade work where a reliable, economical sheet metal screw is needed.

This screw is commonly used in HVAC duct assembly, sheet metal fabrication, electrical enclosure work, and light structural applications. The pan head profile keeps a low, broad bearing surface that distributes clamping load without protruding excessively. The slotted drive accepts a standard flat-blade screwdriver or slotted bit, making it accessible with common hand and power tools. The 100-piece pack quantity suits routine service work and small shop needs.

Key Features

• No. 2 thread size with Type AB point for positive starts in thin-gauge sheet metal
• Pan head profile with slotted drive — works with standard flat-blade bits
• 0.5 inch length under head suits thin-gauge and overlapping sheet metal joints
• Grade 2 steel construction for consistent thread form and shear strength
• Zinc finish provides basic corrosion protection in dry indoor environments
• 100-piece box quantity for consistent jobsite or shop inventory

Compatibility

Designed as a standard Type AB sheet metal screw for use in light-gauge sheet metal, HVAC ductwork, electrical enclosures, and similar thin-material fastening applications requiring a No. 2 pan head slotted fastener.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and sheet metal workers using a flat-blade screwdriver or slotted power bit. Pre-drilling is not required with Type AB point screws in most light-gauge applications, though a center punch or awl start can improve alignment on finished panels. Avoid over-driving, which can strip the shallow thread engagement in thin-gauge material. No special codes govern the fastener itself, though the surrounding assembly must comply with applicable mechanical, electrical, or HVAC installation codes.