Value Collection SMPPI0-600750-100BX No. 6 Sheet Metal Screw

Product Description

The VALUE COLLECTION SMPPI0-600750-100BX is a No. 6 pan head sheet metal screw designed for fastening thin metal panels, ductwork, brackets, and similar light-gauge metal assemblies. The Phillips drive and Type AB point make it well suited for power-tool installation into pre-punched or self-piercing applications. At 0.75 inches length under head, this screw is a standard size for light-duty sheet metal work in HVAC, electrical enclosure, and general trade applications. Finished in zinc for basic corrosion resistance, it is made from Grade 2 steel. This box contains 100 screws, making it a practical quantity for everyday field and shop use.

This screw is commonly used in residential and commercial HVAC ductwork assembly, electrical panel and enclosure fastening, metal framing, and general sheet metal fabrication. The pan head profile provides a low-profile bearing surface suitable for flat or slightly curved metal stock. The Type AB point is a coarse-thread, self-starting design that works in thin-gauge sheet metal without requiring a tapped hole. HVAC technicians, electricians, and sheet metal workers are the typical installers in both field and shop environments.

Key Features

• No. 6 thread size — standard gauge for light sheet metal fastening applications
• 0.75 inches length under head — suits thin-gauge panel and ductwork assembly
• Pan head profile — wide, flat bearing surface for flush or near-flush seating on flat stock
• Phillips drive — compatible with standard No. 2 Phillips bits and screw guns
• Type AB point — coarse self-starting thread for use in pre-punched or thin sheet metal
• Zinc finish — provides basic corrosion resistance for indoor and sheltered applications
• Grade 2 steel construction — adequate strength for standard light-gauge sheet metal work

Compatibility

Designed for use in light-gauge sheet metal fastening applications including HVAC ductwork, electrical enclosures, metal panels, and similar assemblies where a No. 6 pan head sheet metal screw is specified.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and sheet metal workers using a No. 2 Phillips bit with a standard screw gun or hand driver. Ensure power is isolated to any electrical enclosure before fastening. Use appropriate PPE when working with sheet metal edges. Do not overtorque — strip-out in thin-gauge metal is a common failure when using power drivers without a clutch setting.