Value Collection SMPPI0-600250-100BX Sheet Metal Screw No 6

Product Description

The VALUE COLLECTION SMPPI0-600250-100BX is a No. 6 pan head sheet metal screw with Phillips drive, sold in a box of 100. Each screw measures 0.25 inches in length under the head and features a Type AB point for fast starts in thin-gauge sheet metal. The fastener is Grade 2 steel with a zinc finish for basic corrosion resistance. This screw is a standard trade consumable used in HVAC, electrical, and light-gauge sheet metal fabrication. Installers use these for securing ductwork panels, electrical enclosures, junction box covers, and similar thin-metal assemblies.

This screw is suited for residential and light commercial applications where a No. 6 fastener is called for in thin sheet metal, metal studs, or similar substrates. The pan head profile sits low against the workpiece and provides a wide bearing surface. The Phillips drive works with standard bit drivers and drills. The Type AB point is self-starting in pre-punched or pre-drilled holes in light-gauge material, reducing the need for pilot drilling in many field conditions.

Key Features

• No. 6 thread size for light-gauge sheet metal fastening
• 0.25-inch length under head suits thin-panel and enclosure work
• Pan head profile provides broad bearing surface with low-profile seating
• Phillips drive compatible with standard No. 2 Phillips bits
• Type AB point for self-starting in pre-punched sheet metal
• Zinc finish provides basic corrosion resistance for indoor and protected applications
• Sold in a box of 100 for job-site and shop stocking

Compatibility

Designed as a standard No. 6 pan head Phillips sheet metal screw suitable for use in light-gauge sheet metal assemblies, HVAC ductwork, electrical enclosures, and similar thin-metal fastening applications.

Installation Notes

Sheet metal screws of this type are installed by licensed HVAC technicians, electricians, and sheet metal workers. Always de-energize electrical equipment and verify lockout before fastening into energized enclosures. Use a properly sized No. 2 Phillips bit to avoid cam-out and fastener head damage. For HVAC duct applications, follow SMACNA guidelines for screw spacing and sealing requirements.